This shutter plate will allow you to protect the Mychron, especially bad weather, and hide the location of the battery.

The 150 cm extension cable for Mychron4, Mychron5 and Mychron6 2T is a essential accessory For pilots and mechanics wishing accurately monitor critical temperatures from their 2-stroke engine. This cable, Delivered original with MyCHRON systems, allows for Connect two temperature probes directly to the telemetry box, providing a optimal control Motor settings.

With a Length of 1.50 meters, this cable connects to the 7-pin "Temp 'socket Located at the back of the 2T MyCHRON case, and allows to measure:

• The water temperature cooling system.
• The exhaust temperature or bougie, two essential data for Optimize engine settings and overheat.

AIM battery for Mychron 5 Lithium

This cable is the primary sensor of your on-board computer. It works by magnetic induction : wrapping around the wire bougie, it captures the electric pulse sent by the coil to each spark and translates it into exploitable data (lathes per minute) on your screen.

• Accurate reading: Allows you to monitor the engine speed in real time to optimize your carburation and transmission reports.

• Non-invasive installation: No need to cut or strip cables, the signal is captured through the insulation of the wire of bougie.

• Complete kit: Supplied with maintenance clips to ensure that the wire does not move despite intense vibrations.

Only for Mychron 4 or 5

Not compatible with MyCHRON 5 2T

Cylinder head cap M18x1.5