Full description of the product (H1: Carburetor elbuator kit 90 ° Type Dell'ORTO SHA / PHBG)
This 90 ° elbow kit (or cable guide) is the essential part to optimize the passage of your accelerator cable or starter. Designed specifically for type carburetors Dell'ORTO (SHA and PHBG Series)It makes it possible to deviate properly the cable when the space under the tank or the frame is restricted (current on MBK 51 mopeds, Peugeot 103, scooters and mécabites).
Made of high-strength treated steel, this kit resists perfectly with vibrations and hydrocarbon projections. It eliminates mechanical friction in the sheath, guaranteeing a ultra-flexible gas handle and an instantaneous handle return for your safety.
What does the kit include?
-
1 90 ° rigid metal elbow (Standard M5 or M6 thread depending on arrival)
-
1 adjustment screw (tensioner) To adjust the cable tension to a millimeter
-
1 lock nut To freeze the setting
-
1 rubber protection cap (bellows) To make the system waterproof and dust
- 3. Tip in Michel (the corner of the expert)
"The guys, two small old old tips for this elbow. \ N \ N-NEGREE, when passing the new steel cable in the elbow at 90 °, put it A drop of engine oil or fine grease. It avoids that steel rubs dry inside the elbow and it will make you a handful of soft gas like butter. \ N \ NCYECTOly: Never neglect the small rubber bellows! If it is badly put, the fleet seeps into the elbow in rainy weather, goes down into the carbz and there ... it's the failure assured after 2 kilometers. "
- 4. The mounting guide: step by step
1.Preparation:5 min.Disassemble the hat (bushel) of your carburetor. Remove the existing accelerator cable from your gas handle and pull it out of its sheath.
2.Installation Elbow:2 min.Screw firmly but without forceing the new elbow at 90 ° on the top of the carburetor cap. Orient the angle of the elbow towards the direction where your cable will come (forward of the machine).
3.Montage Tensioners:3 min.Screw the adjustment screw and its nut halfway on the free end of the metal elbow. Put on the rubber cap on your cable sheath.
4.Passage of cable and reassembly:10 min.Slide the lubricated cable into the sheath, and then pass it through the elbow at 90 ° to come out inside the carburetor cap. Hang it on a bushel, put the spring back, and close the carburetor.
5.Regregation of the voltage:5 min.Adjust the adjusting screw to leave a slight set of 1 to 2 mm to the gas handle. Important: Turn the handlebar to the left and bottom right to check that the engine speed does not mount itself!
❓ 5. FAQ SEO (Frequently Asked Questions)
Q: Is this 90 ° elbow compatible with my original carburetor?
A: Yes, if you have a dell'orto SHA (14, 15, 16) or PHBG (15 to 21 mm) carburetor or their replicas (original type). Remember to check if your carburetor cap requires a thread M5 (5mm) or M6 (6mm).
Q: Why install a 90 degree elbow rather than a right passage?
A: The 90 ° elbow prevents the gas cable sheath comes to Butter against the frame or tank of your motorcycle / moped. It deletes net folds that may block or cut off the accelerator cable.
Q: Does the kit understand the gas cable?
A: No, this kit includes the metal elbow, the voltage screw, the nut and the hooded cap. The gas cable and its sheath are sold separately on our shop.