Ecran ZAMP fumé clair Z-20 series

• Clear Smoked Screen "Z-20 Series".
• Designed for RZ-35 / 35E / 58/40/42 / 44C / 44CE.
• Available in FIA approved version for RZ-35E and RZ-44CE.
• Thickness 3 mm.
• Built-in Tear Supports.
• Tip: Protect your smoked screen with TEAR-OFFS ULTRA-SHIELD.

Replacement Screen Z-20: Note: Do not use electrical tools and do not overcome the screws when changing the protections. Step 1 - Place a towel on a flat surface and place the helmet on it. Step 2 - Remove the shield pivot tensioners on each side. (This is the smallest screw on the sides of the shield.) Step 3 - Remove the shield pivot screws on each side. (This is the biggest screw on the sides of the shield. For best results, we suggest using a quarter to loosen / tighten these screws.) Step 4 - Remove the shield. We suggest you use a mild fabric towel to wipe the rubber seal as well as the location where the shield mounts on the helmet for better results. Step 5 - Place the new shield on the helmet. There are two white washers that go between the shield and the helmet, make sure they are in place before reinstalling the shield's pivot screws. Step 6 - Hand screw the shielding pivot screws to maintain the shielding in place. Once threaded by hand, use a quarter to tighten until it is well adjusted with the helmet hull. Do not tighten too much. Step 7 - Hand press the shield pivot tensioners, then tighten the desired voltage for the movement of the shield.